Install Deadbolt Locks

December 31, 2020

Snap on the decorative outer plate. You will line up the holes with the proper drill bit and then secure the deadbolt with the required screws.

How To Install A Deadbolt Lock How Tos Diy

Drill a Hole Through the Edge of the Door.

Install deadbolt locks. Get Results from 6 Engines at Once. Retract the deadbolt and install the thumb turn assembly. Installing a deadbolt lock is.

This will create a mark to work off of for the strike box. Calling a locksmith out for this how to install a deadbolt lock job will cost 150 or more but you can install a heavy-duty deadbolt yourself in less than an hour for a third of the price. Install and secure the deadbolt.

If your deadbolt is operating smoothly then continue with the install. Install the faceplate to the door and the strike plate to the door frame. After reviewing the instruction template you will know more about how to install a deadbolt lock for your safety and security.

Drill Holes and Secure the Strike Plate. Install the deadbolt lock about 44 inches above the bottom of the door. Get Results from 6 Engines at Once.

Install the Cylinder And Thumb Lever. After installing the deadbolt into the door use a soft wax or marking grease at the tip of the bolt to mark where it will enter the door jamb. You can complete your deadbolt installation in just a few minutes with minimal tools - tape measure and a 2 Phillips Head screwdriver are all you need.

Cut a Hole for the Deadbolt. The majority of Angies List members though reported paying less than 200. Ad Search Locksmith Newcastle.

Secure the Bolt To the Door. Install the cylinder assembly. Ad Search Locksmith Newcastle.

If your deadbolt has a keypad install it now following the manufacturers instructions. Then pull out the lock and thumb turn assembly. David Helms owner of highly rated E S Security and Locksmith in Charlotte NC says it costs 55 for the trip 35 for the deadbolt and 45 to drill and install the deadbolt on a wood door or 50 to install it on a metal door.

Mortise the Area Around the Faceplate. Keep in mind that an electric drill is not recommended for installation as it can easily strip the screws and damage your lock. Installing a deadbolt lock is easier than you may think.

To cut through a steel door make sure you get a bimetal hole saw set. Youll have to adjust the position a bit if you have a combination storm door so as not to interfere with the storm doorknob or lock. Then remove the actual deadbolt leaving an empty hole for the new lock.

Thats about average for a good deadbolt and a hole saw set. Place the keyed side on the outside of your door with the thumb latch on the doors inside face. Test the deadbolt by closing the door and using a screwdriver to extend the latch and test that you have a smooth operation.

Hand-thread the screws then tighten them using a screwdriver or power drill. Leah from See Jane Drill shows you how you can DIY with a deadbolt installation kit1 Locate your d. Install the bolt assembly from your deadbolt set into your 1-inch hole making sure to secure it with the screw included in the set.

Thread any cables over the physical deadbolt and make the connections on the other side. If you have an existing deadbolt the job will be easier to remove it takes out the screws. Choose a position on the door for the lock.

Attach the interior part of the deadbolt lock by inserting the two provided long screws through the interior plate the two screw holes in the bolt and into the exterior side of the lock. Depending on the type and class you buy a deadbolt and installation typically cost 100 to 250. Secure with the long machine screws.

Lock Installation Services Local Door Lock Installation Services