How To Change Rear Brakes

August 22, 2020

One of the keys to knowing when you should change the rear brakes on your vehicle is to determine if they are wearing out. Be sure to check your brake fluid level after you move everything around and change it if necessary.

How To Change Rear Brake Pads Diy Family Handyman

Adjust the brakes through the drum or through the backing plate till a slight drag on the brake drum is felt.

How to change rear brakes. Steps for changing your brake pads. The best way to do this is to use the diagnostic tool or parking brake tool to do. Install the drum brake over the brake shoes.

Usually the front brakes need to be replaced before the rear brakes but there are exceptions to any situation. Servicing the rear brakes on time will prevent the need Ford car high-cost repairs and possibly traffic accidents. A bad master cylinder would interrupt the fluids flow into the cylinders causing you to lose brake resistance.

If that is the case be sure to liberally spray the drums with brake cleaner to remove any of the film that may be present before installing them. Replace the retaining clips. If you can hear the rear brakes in your Ford car squeal every time you apply the brake pedal those are the wear indicators on the brake pads telling you it is time to change the pads.

You will hear the parking brake motors sound for 2-3 seconds until the parking brake is engaged. Slide in the new brake pads. Take the caliper and slide it over the brake pads.

Torque the lug nuts and reinstall the hub cap. This can be a hassle due to the tight fight but just wiggle it on there a little bit should slide right on. Put the two 12mm bolts back into the caliper and tighten them down.

Remove the slider bolt. The master cylinder is where the brake fluid is stored and sent to each cylinder. Do not over tighten the brakes or they could lock up.

Slide out the old brake pads. The brake fluid is what applies force to the front brakes rear brakes and drums. However in many cars it will work to engage the parking brake with the button.

Please DONATE if you want the FREE videos to keep coming. Listen for grinding or unusual noises in the rear brakes when you come to. Many drums will become coated in a thin oily film to prevent them from rusting during shipping and storage.

Remove the jack stand. Prepare the new drum brake. Check brake adjustment and readjust as needed to have a slight drag on the drum.

Once the drum is clean and ready to install slip it over the brake. Pivot the caliper up.

Changing Brake Pads Should You Do It All At Once