How To Remove Drill Chuck

January 22, 2020

As with method 1 that should loosen the chuck to the point where you can unscrew it by hand. Insert a screwdriver of appropriate size and turn clockwise to remove the reverse-threaded screw.

Remove Chuck From Drill And Drill Motors

The screw is usually coated with thread-locking fluid so this may require some force.

How to remove drill chuck. Part of the series. Most cordless drill chucks have this screw on the base. The screw is responsible for fastening the base to the case of the drill.

Loosen the jaws of the chuck to their widest extent. Clean it up After you are done with the removal process of the chuck you must get it cleaned. In this video I show you how to remove the chuck from a makita cordless drill.

1 If the unit has this screw place the chuck key with the chuck facing toward you into one of the holes on the right side of the chuck. Keep the right angle and the perfect speed and you can easily remove the chuck from the drill press. Open the chuck as wide as it will go and look down the throat with a flashlight to determine whether you need a screwdriver or an Allen wrench to remove the chuck screw.

Often people ignore the importance of cleaning the chuck. For this youll have to widen the jaws until theyre completely loose. The first step to remove the chuck then is to first take its collar off.

Hammer the spindle out with a metal punch. Remove the screw in the center of the chuck. Lay the drill down on its side with the chuck hanging over the edge of a bench as pictured.

Strike the key in a clockwise direction with a wooden mallet or similar object. For drill chucks and other power drill parts see our Drill Parts page to find the replacement parts you need. This is the 12 volt Makita drill although the same rules apply for most all dr.

Most reversing drills have a left hand threaded screw located inside the bottom of the chuck. How to Remove a Drill Chuck. On most keyless chucks youll see a screw at the base of the chuck fastening it to the drill case.

The first thing you need to do is remove the screw at the center of the chuck. Hammer the punch through the hole until the spindle comes off the chuck. Then turn the other drill on suddenly such that it will rapidly and sharply rotate the chuck which youre trying to remove in the counter-clockwise direction.

Hold the drill firmly to the bench and hit the allen wrench downward using sharp blows with a hammer. The chuck will be a lefty loosey to remove. If it doesnt then try another method.

Place a metal punch in the center hole of the chuck where the end of the spindle is sitting. When removing a drill chuck check with the manufacturer of the drill to find out if the. Use a pair of snap ring pliers to remove the snap ring.

Once the screw is out grab the largest allen wrench you have and tighten the short end into the chuck. Before you begin removing the old chuck be sure to unplug the drill or remove the battery. In cases like these drill chucks usually come off the drill with the arbor shaft and chuck collar still attached to the chuck.

How To Install A Keyless Drill Chuck Diy