How To Build Wood Steps

October 11, 2019

To build stairs start by cutting the stringers which are the pieces of wood that run diagonally under the stairs and hold them up. Attach the Plate to the Footer Cut the two-by-four to 36 inches.

How To Build Outdoor Wooden Steps To Spruce Up Your Entry Patio Steps Exterior Stairs Patio Stairs

Building outdoor wooden steps requires a clear level area.

How to build wood steps. If you do not have stringers you can buy precut ones at your local build it center. Set a long level on top of the decking and measure the height at the point where you want your steps to end. The riser rests on the front face of the stringers between the bottom edge of the step above and on top of the back edge of the step.

Attach this to the bottom or footer as a plate to receive the bottom ends of the stringers. So I only have to measure and cut the stringers the pieces of wood that support the steps for 2 steps. Place the risers underneath each step.

Finally install your banister again using nails and wood glue. Next level the ground and build up low spots with fill dirt so the area slopes away from the house. The method of attaching the plate to the footer depends on the footer material.

Start by measuring the width of the opening then cut a treated 2x4 to length to attach to the side of the house as an anchor for the stringers. Remember to take 3 off the length of the anchor. This can be done with nails or brackets.

Divide the rise 16 ¾-inches by 3 and we are left with each step being 5 916-inches. Fit the treated 2 x 4 into the notch and press it flush to the wall. Start by removing shrubs and plants from the spot where the steps will be located which could be alongside the house a porch or a deck.

Trace along both inside edges of the framing square. Install the Treated 2x4s. Then install the stringers to the top and bottom of the area where youre building the stairs by screwing them into metal joists.

Slide the square down the wood to the next step location lining the edge of it up with where your last scribe line left off and continue with. Use a masonry bit to drill through the 2 x 4 and into the concrete floor then attach the 2 x 4 to the floor with concrete nails. Apply wood glue over the joints to secure.

Position one stringer against the wall and have a helper hold it in place. Fasten the steps in place using a hammer and finish nails. These steps were build with 2 ten foot 2X12s 2 six foot treated 4x4s two bags of ready-mix concrete two post bases and 3 six foot pre-cut stringers.

Align the rounded wood steps on top of each step support of the stringers. Allow time to build some simple steps generally a weekend. For example if the height is 55 inches divide this measurement by 7 the ideal height in inches for each step.

Use corrosion resistant screws and nails to assemble the steps. Your steps can then be nailed onto your stringers. Use this measurement to determine the number and height of the risers.

Now you can attach the stringers to the mobile home or RV.

How To Build Wooden Steps Or Decks Dengarden

How To Build Outdoor Wood Steps How Tos Diy